Acquastop® Modular with stackable staves is used to protect large flooding fronts: gates, industrial doors, parking areas, etc.
Anti-flooding barrier with stackable staves and aluminium side guides and compression levers
Modular allows the protection of large openings such as entrance gates to villas, industrial doors and parking areas.
For the modular anti-flooding barrier mounting, two permanent side guides are required, with a closing casing and lids to be used for seal protection when the anti-flooding barrier is not in use
When the tread surface is irregular (joints between tiles, cement, asphalt, etc.) the special 130 × 4 mm A21000 Modular Flat Profile must be installed.
The modular anti-flooding barriers are supplied exclusively in the heights indicated in the dimensions table, while for the width they are made to measure. For openings at risk of flooding with a width of more than 350 cm, or when the end-customer requires staves of reduced width, it is possible to combine two or more barriers by means of one or more Modular A18000 Portrait Doors with lateral guides.
We can also supply, with the approval of the Technical Office, anti-flooding barriers with staves wider than 350 cm: in this case the use of the special A17000 Modular Support and Tensioning Shaft is required. In the same way it is possible to provide anti-flooding barriers over 220 cm in height.
The modular anti-flooding barrier is also safe and reliable. A sample of this anti-flooding barrier, 350 cm wide and 220 cm high, was tested by an important national testing laboratory, the Istituto Giordano S.p.A., which certified that the flow of water through the barrier was not measurable.